User Manual

TOYOTA TUNDRA 2000 & NEWER (STANDARD CAB LONG BOX ONLY)

CAUTION!

Read pages 2-3 of these instructions before starting installation. Failure to do so could result in significant vehicle damage!

NOTE: For Toyota Tundra application, part #58197 spacer kit is required. Stack (1) 3/16” and (1) 5/16” thick

slotted spacer to avoid crushing of truck bed.

32 1/2” Long Box (Only)

Side Bracket

Axle Center

Front

Vehicle

Rear Edge of

Truck Bed

1/4 1.5-3

1/4 2

* Optional weld

pattern

Drivers side shown

Measure from Rear Edge of truck

bed to rear edge of base rail.

Long bracket

Short bracket

ROW 1

ROW 2

ROW 3

ROW 4

King Pin Centered approx.. 1 1/4”

forward of Axle Center

Each base rail must have a

bolt in either of the marked

center holes. Check for

obstructions before drilling.

CAUTION!

Check for obstructions before drilling. Failure to do so could result in damaged fuel or brake lines, structural members, etc.

Cequent Towing Products does its best to communicate tow vehicle manufacturer changes; however, it is ultimately the

responsibility of the installer to prevent damage due to installation.