Product Manual

ManualsBrandsPro Series ManualsPrimaryS3100 - 1 HP Cast Iron Submersible Sump Pump w/ Deluxe Controller & Dual Float Switch

Model Discharge Amps Max Solid Max GPM / GPH GPM / GPH Switch

No. HP Volts Diameter @ 10

⬘

Handling Head @ 0

⬘

@ 10

⬘

Included

S3033

3 115 1

2⬙ 4.0

8⬙ 30⬘ 65 3900 50 3000 DFC2

S3050

2 115 2⬙ 4.3

8⬙ 33⬘ 71 4260 65 3900 DFC2

S3100 1 115 2⬙ 11.5 1

4⬙ 52⬘ 99 5940 92 5520 DFC2

S5033

3 115 1

2⬙ 4.0 1

2⬙ 26⬘ 71 4260 59 3540 DFC2

S5050

2 115 2⬙ 6.8 1

4⬙ 36⬘ 96 5760 83 4980 DFC2

E7050

2 115 2⬙ 4.6 2⬙ 26⬘ 56 3360 47 2820 1020012

E7100 1 115 2⬙ 12.8 2⬙ 34⬘ 130 7800 114 6840 1020012

The Dual

Float

(included

with all S3

and S5 series

pumps)

Specifications

S5 Series

Dewatering Sump Pumps

5 Year Warranty

E7 Series

Sewage Pumps

3 Year Warranty

PHCC Pro Series

Sump Pumps

Instruction Manual

& Safety Warnings

Important Safety Instructions and Warnings

SAVE THESE INSTRUCTIONS. This manual contains important SAFETY WARNINGS and

OPERATING INSTRUCTIONS for the PHCC Pro Series pumps. You will need to refer to it

before attempting any installation or maintenance.

ALWAYS keep these instructions with the unit so that they will be easily accessible.

Failure to read and follow these warnings and instructions could result in property

damage, serious injury, or death.

• ALWAYS disconnect the pump from the power source before servicing or making

adjustments.

• NEVER handle the pump or motor with wet hands or when standing on a wet or damp

surface while the pump is plugged into the power source.

• MAKE SURE THERE IS A PROPERLY GROUNDED RECEPTACLE AVAILABLE. This pump is

wired with a 3-prong grounded plug. To reduce the risk of electric shock, be certain

that it is only connected to a properly grounded, 3-prong receptacle (preferably with

ground fault circuit interrupt). If you have a 2-prong receptacle, have a licensed

electrician replace it with a 3-prong receptacle according to local codes and ordinances.

• NEVER bypass grounding wires or remove the ground prong from the plug.

• DO NOT use an extension cord. The electrical outlet should be within the length of the

pump’s power cord, and at least 4 feet above the floor level to minimize potential

hazards from flood conditions.

• DO protect the electrical cord from sharp objects, hot surfaces, oil, and chemicals.

Avoid kinking the cord.

• MAKE SURE the supply circuit has a fuse or circuit breaker rated to handle the power

requirements noted on the nameplate of the pump.

• DO NOT remove the power supply cord and strain relief or connect the pump directly to

the conduit.

• NEVER install the pump in locations classified as hazardous in accordance with the

National Electrical Code, ANSI/NFPA 70.

• ALWAYS install the pump in accordance with the National Electric Code and all

applicable local codes and ordinances. All wiring should be performed by a licensed

electrician.

• DO NOT use the power cord or strain relief to carry the pump. Use the pump handle.

• DO NOT expose the control unit to rain or snow.

• DO NOT operate the pump or control unit if it has been damaged in any way.

• DO drill an air bleed hole in the discharge pipe when a check valve is used. Drill the

hole angled toward the bottom of the sump to avoid splashing water outside the sump

pit. If a hole is not drilled above the pump, an air lock may prevent the pump from

operating, and the basement will flood. The best location for the hole is about 3⬙

above the discharge outlet on the pump. The hole must

be drilled below the check

valve. The optimum size of the hole is different for different pumps. Drill a 1/8⬙

(3.2mm) hole in the discharge pipe for the S3 Series and S5 Series pumps. Drill a 3/16⬙

(4.76mm) hole in the discharge pipe for the E7 Series pumps.

• DO NOT use sump pumps in pits handling raw sewage, salt water, or hazardous liquids.

S3 & S5 Series pumps are not designed for this purpose. E7 Series pumps are sewage

pumps.

• DO NOT disassemble the pump or control unit. When service is required, contact

Glentronics technical support at 800-991-0466, option 3. Return the product to the

manufacturer for any repairs at the following address:

Glentronics, Inc.

640 Heathrow Drive, Lincolnshire, IL 60069

 CAUTION

 WARNING

S3 Series

Dewatering Sump Pumps

3 Year Warranty

Deluxe

Dual Float

Controller

(included with

all S3 and S5

series pumps)

Risk of electric shock. To reduce this risk, observe the

following precautions.

To reduce the risk of hazards that can cause injury or

property damage, observe the following precautions.

Summary of content (4 pages)

PAGE 1
PHCC Pro Series Sump Pumps Instruction Manual & Safety Warnings S5 Series Dewatering Sump Pumps 5 Year Warranty S3 Series Dewatering Sump Pumps 3 Year Warranty E7 Series Sewage Pumps 3 Year Warranty Specifications The Dual Float (included with all S3 and S5 series pumps) Deluxe Dual Float Controller (included with all S3 and S5 series pumps) Model No. Max GPM / GPH Head @ 0⬘ GPM / GPH Switch @ 10⬘ Included Volts S3033 S3050 S3100 1 /3 /2 1 115 115 115 11/2⬙ 2⬙ 2⬙ 4.0 4.3 11.
PAGE 2
UNION/CHECK VALVE Installing the Double Float PUMP FLOAT WIRE (included with S3 and S5 Series pumps) WIRE PIT COVER The PHCC Pro Series double float switch is easy to install by using the enclosed metal hose clamp. DRAIN TILE 1. Hold the float switch to the discharge pipe so the cage is below the bracket. DUAL 2. Secure the float to the pipe with the enclosed FLOAT hose clamp, but do not completely tighten the PRO SERIES PUMP clamp at this time. AIR BLEED HOLE 3.
PAGE 3
2. The power is out and the 9V battery is discharged. 3. The controller is not functioning. Contact Glentronics service department. 2. Replace the pit cover making sure not to pinch or crimp the pump wire with the cover. The pit cover either has a ‘hole punch’ that will allow the cord to be passed through or one can be drilled. The 9-volt battery is low 1. The 9-volt battery located in the top of the control box is coming to the end of its useful life. Replace it with a new 9-volt alkaline battery. 2.
PAGE 4
Warranty GLENTRONICS, INC.