User guide

Manufactured by ProBuilt Professional Lighting: 877-707-0800
Thank you for purchasing Wobblelight
®
Super Duty
IMPORTANT SAFETY INSTRUCTIONS
WARNING !!!
READ AND UNDERSTAND ALL INSTRUCTIONS
Failure to follow all instructions listed below may result in electric shock, fire and/or serious injury.
SAVE THESE INSTRUCTIONS
This manual contains important safety and operating instructions for Wobblelight
®
Super Duty portable job site lighting. Before using Wobblelight
®
Super Duty,
please review all of the following safety instructions carefully and read all labels on the Wobblelight
®
Super Duty unit.
INSTRUCTIONS PERTAINING TO THE RISK OF FIRE, ELECTRIC SHOCK, EXPOSURE TO UV RADIATION AND INJURY TO PERSONS:
WARNING: To reduce the risk of fire, electric shock, exposure to excessive UV radiation or injury to persons:
DO NOT connect Wobblelight
®
to power source until the bulb is installed and the unit is completely assembled.
Metal halide bulbs get EXTREMELY HOT immediately upon illumination and can cause burns.
Bulbs stay hot for an extended period of time after Wobblelight
®
unit has been turned off, and can continue to cause burns.
DO NOT attempt to remove the protective lens to change bulbs unless the Wobblelight
®
unit is disconnected from the power source and the bulb has
completely cooled.
Not for use in wet locations. DO NOT use Wobblelight
®
where this is potential for exposure to excessive moisture from rain, snow, ice, water spray or
standing water.
Connect Wobblelight
®
only to 120 volt, 60 Hz power source which is protected with a ground-fault circuit interrupter (GFCI) and over-current protection
which is rated no higher than 20 amps. Any other connection voids warranty.
Keep away from flammable materials.
Wobblelight
®
must be operated in the upright position only. DO NOT mount Wobblelight
®
units upside down or restrain them such that they lay on their
side.
DO NOT lift, hoist or suspend Wobblelight
®
above people or work areas.
Use only approved extension cords in good condition and of the appropriate type, gauge and length. To connect Wobblelight
®
units to a power source and
to each other, it is recommended to use 3-wire, 10-gauge extension cords that do not exceed 25 feet in length.
Keep extensions cords dry and use ground fault circuit interrupter (GCFI) devices in accordance with all applicable electrical code requirements.

Summary of content (6 pages)