Instruction manual

INSTALLATION (Continued):
Positioning and Mounting:
Wall-mounted units:
The wall-mounted TYTAN units must be anchored to a support structure that can
support at least 275-pounds (125 kg). We recommend that the mounting bolts are no
smaller than a 3/8-16 thread.
We recommend that the unit is mounted such that the temperature controller is no more
than 78-inches (2 meters) above the floor level (see figure 5).
Free-standing units:
Move the unit into position by lifting the unit from underneath using a fork truck or other
suitable handling equipment. Position the equipment to avoid damaging the cooling
fans located on the bottom of the unit.
The castors should not be used to move the
unit over long distances or on uneven surfaces.
They are intended to facilitate small
adjustments to the position of the unit at its
place of operation. Move the unit slowly, as
there is no means of slowing or stopping the
unit. Ensure that there are sufficient personnel
to move the unit safely. Failure to follow these
instructions can result in serious personal
injury and/or damage to the unit.
Place the unit on a hard, level surface. Ensure the unit is secured so as not to roll as
the casters are unlocked. Once the unit is in position, lock the four castors.
Ensure the unit is on a smooth, level surface
and there are sufficient personnel to hold the
unit in place. As the leveling feet are retracted
and the unit rests on the castors unexpected
movement may result. Failure to properly
secure the unit may result in serious personal
injury and/or damage to equipment.
M-45-02 TYTAN Manual
Revision - Date: 01 – 11/16/07
17