Instruction manual

OPERATIONS for E5CK (Continued):
Changing Primary Set Point:
The process Set Point can be changed in the level 1 mode menu. 3.
4. Press the Display Key for a minimum of one second to enter the level select
mode.
Press the up or down arrow key to select the desired level. (Level 1 for process
set point adjustment).
5.
6. Press the Display Key for a minimum of one second to enter the selected
level mode menu.
Press the Display Key for less than one second to cycle through the selected
level mode menu until (SP-0) is shown on the upper display.
7.
Press the up or down arrow key to adjust the (SP-0) value to the desired point. 8.
9. Press the Display Key for a minimum of one second to once again enter the
level select mode.
Press the up or down arrow key to select the desired level. (Level 0 for normal
control operation).
10.
After changing the process set point (SP-0) on the Omron controller, you must
manually adjust the SP2 setting on the Future Design over-temperature control.
( See OPERATIONS Over-Temperature Controller FDC-L91 section.
M-45-02 TYTAN Manual
Revision - Date: 01 – 11/16/07
36