Owner`s manual

INSTALLATION:

1.Surround must be installed flush with wall.

Baseboards will prevent proper installation of

surround. Baseboards can be altered to fit sur-

round by cutting that part within 34 1/2” distance

from the wall corner.

2.Surround must be attached to either a wall stud

or wall anchor. Use a tape measure to determine

correct height from floor to location of mounting

strips. (See Figure 1). Make sure point of the

mitered edge of mounting strip touches the

corner. Use a level to ensure mounting strips are

evenly balanced.

IMPORTANT: Failure to balance mounting

strips with a level could result in uneven

surfaces on fully assembled surround.

3.Fasten mounting strip to wall by inserting 2"

screws provided along the predrilled holes of

mounting strip. If predrilled holes of mounting strip

do not line up with wall studs, drill new holes

where wall studs are or attach to wall with wall

anchors. (See Step 4 below.)

4.To use wall anchors, drill holes at marked loca-

tion using 5/16” drill bit. Fold wall anchor (see

Figure 2) and insert (wings first) into hole. Tap

anchor flush into wall. For thin walls, insert red

key into wall anchor and push to “pop” open an-

chor wings (see Figure 3).

5.Repeat steps above to attach other mounting

strips to wall. Make sure mitered edges fit to-

gether to form a clean joint in the corner of the

wall.

INSTALLATION INSTRUCTIONS

For CORNER SURROUND AND HEARTH

READ INSTRUCTIONS BEFORE BEGINNING INSTALLATION. Check to see that you have

the following. If any part or parts are missing, contact the dealer where you bought the sur-

round and hearth.

TOOLS REQUIRED:

Measuring Tape, Pencil, Level, #2 Phillips Screw Driver, Hammer, Electric Drill, 5/6" Drill Bit,

Hand or Electric Saw

Figure 1

Figure 3

Figure 2