Owner`s manual

8
7
Operating Instructions
Remote Control Front
Remote Control Back
Before programming your transmitter you must
first insert two “AAA” batteries.
Make sure the main power on/off switch is “ON”
position.
1. The ON/OFF button:
*Note: When Fireplace is first operated,
the default setting will be: brightest
flame, and full heating To turn on Heater,
press the “ON/OFF” button. To turn off
heater,press the “ON/OFF” button again.
2. Flame brightness setting:
There are three settings for flame
brightness: “1”,“2”and “3 (OFF)”.
Press button to decrease the
flame brightness, and button to
increase the flame brightness.
3. Heating level setting:
There are three settings for heating level:
“HI”, “LOW”, and “OFF”. Press button
to decrease the Heating level and
button to increase the Heating level.
If set on “HI”, two heating elements will
be approximately 90°F; set on “LOW”,
the set room temperature will be
approximately 70°F.
Press “ON/OFF” button to turn on or off
the fireplace.
Press “HEAT Adjust” button to control
heater.
Press “FLAME ” button to control the
Flame brightness.
Manual Operation (without
handheld remote)
Heater Front View
(SFE24 Series )
Heater Front View
(SFE32 Series )