Operating instructions

6
GROWMASTER PROCOM SET UP
SET SYSTEM
The SET SYSTEM mode is used to set the system clock and date, manually view the system's sunrise and sunset
times, adjust the system photocell, and to set the custom identification that will appear on the display during the
run mode. Also, this mode is used to determine the times of day, either by sunrise, sunset, clock, or a
combination of means, by which the four separate settings will apply. The four settings are listed as DAY,
MIDDAY, EVENING, and NIGHT. In addition, the input and output configurations that have been pre-programmed
into the PROCOM series control can be reviewed here. The air circulation functions may be defined in this mode.
Finally, the remote ID code for use with the GROWLINK PC communications program is set here.
1. Enter the SET SYSTEM mode.
2. Use the PRIOR-NEXT switch to advance to the desired item to set.
3. Use the VALUE switch to increase or decrease the display reading. Also use this switch to toggle between
desired choices that the system has internally provided.
Set Clk (12:00) PM
Mon 01/ 02/ 94
Set the correct time and date.
Sunrise 7:00 AM
Sunset 8:00 PM
These are the current values that the control is sensing for sunrise and sunset. There is no need to change these
values; the control will update automatically.
Light Sensor
(Med) Sensitivity
Select the desired sensitivity for the photocell. The photocell will detect sunlight and use this information to put the
control in the evening or night modes. You may also elect to have the Procom enter the evening or night modes
before or after sunset. Also, the Procom can enter the day modes before or after sunrise.
Custom System ID
(OFF)
By changing this to PROGRAM, you may enter a custom ID that will appear on the screen when the system is
running. This may include the name of the range, or other information. If PROGRAM is selected, then use the
VALUE switch to select the desired alphanumeric information, and the PRIOR/NEXT switch to advance to the next
digit. A blank space, punctuation marks, and numerals may also be selected if desired.
DAY Mode
(At Sunrise)
Select how the four modes of operation, DAY, MID, EVE, NGT will be affected. You may choose a switching
action AT SUNRISE, PRE-SUNRISE (Sunset for EVE and NGT) or TIMED. You may also choose NOT IN USE to
disable EVE and MID if desired.
Review I/O
Assignments? (N)
Use this selection to review the assigned inputs and outputs for your system. You may not change them here,
only review them. To change the assignments, please contact Micro Grow for a specific code to enter into your
system to enable you to change the configuration.