PRO-COM V50HYLC V50HYLD Freestanding Electric Fireplace V50HYLC SHOWN Installation Instructions and Homeowner’s Manual WARNING! IF THE INFORMATION IN THIS MANUAL IS NOT FOLLOWED EXACTLY, A FIRE MAY RESULT CAUSING PROPERTY DAMAGE, PERSONAL INJURY OR LOSS OF LIFE. FOR YOUR SAFETY DO NOT STORE OR USE GASOLINE OR OTHER FLAMMABLE VAPORS OR LIQUIDS IN THE VICINITY OF THIS OR ANY OTHER APPLIANCE ANSI/UL1278.
TABLE OF CONTENTS PLEASE READ THE INSTALLATION & OPERATION INSTRUCTIONS BEFORE USING THIS APPLIANCE WE ARE PLEASED THAT YOU HAVE CHOSEN TO PURCHASE AN ELECTRIC FIREPLACE MANUFACTURED BY NANJING PRO-COM ELECTRIC APPLIANCE CO., LTD IMPORTANT: Read all instructions and warnings carefully before starting installation. Failure to follow these instructions may result in a possible electric shock, fire hazard and will void the warranty.
IMPORTANT INSTRUCTIONS GENERAL 1. 2. Read all instructions before using this appliance. This appliance is hot when in use. To avoid burns, do electrically grounded in accordance with local not let bare skin touch hot surfaces. Keep codes with the current CSA C22.1 Canadian local combustible materials, such as furniture, pillows, codes of for USA installations. Follow local codes bedding, papers, clothes, and curtains at least 3 and feet(1m.) from the front of this appliance. 3.
CLEARANCE TO COMBUSTIBLES WARNING: Electrical outlet wiring must comply with local building codes and all other applicable regulations to reduce the risk of fire, electrical shock and injury. Back………………2”/50.8mm Sides……………..6”/156.4mm Floor……………..0”/0mm Top……………….24”/610mm WARNING: Do not use this fireplace if any part of it has been under water. Immediately call a qualified service technician to inspect the fireplace and replace any part of the electrical system if necessary.
MAINTENANCE OF MOTORS The motors used on both blowers fan and flame simulator assembly are prelubricated for the extended warranty of the motor, no further lubrication is required. However, periodic cleaning/vacuuming of the fan/heater unit is recommended. GLASS INFORMATION 1. Under no circumstances should this product be operated with missing or broken glass. 2. Do not strike or slam the glass. 3. Do not use abrasive cleaners to clean the glass.
Operating Instructions This section provides easy step by step instructions for operating your fireplace. 1. Make sure the unit is unplugged from the power source (see warning on page 6) 2. Plug the heater into a 15AMP/120volt outlet. If the cord does not reach, you may use an extension cord rated for a minimum of 1900 watts. To access the controls, open the door of the fireplace at the front of the unit (see Figure A). Figure A A.
This heater is for use on 120 volts only. The cord has a plug as shown at A in the following figure. An adapter as shown at C is available for connecting three-blade grounding-type plugs to two-slot receptacles. The green grounding lug extending from the adapter must be connected to a permanent ground such as a properly grounded outlet box. The adapter should not be used if a three-slot grounded receptacle is available. Warning: Before servicing this heater be sure to unplug heater from wall outlet.
Replacement Parts List V50HYLC Item # Part Description 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 VC Top Panel Right Part Fan/Heater Assembly Synchronization Motor-120Volt AC w/Terminal Cord Power 16/3 HPN w/Terminals ON/OFF Switch VC Top Panel Left Part VC Top Panel (Middle Part) Flame Generator Assembly Light Bulb Socket Right Side-panel Left Side-panel Door Door Pivot Door Adorning Leg(s) Back Panel Electrothermal Hood Door Knob Knob Dressing Air Transfer Panel Glistening Paper Part Number
REPLACEMENT PARTS PICTURES OF V50HYLC 9 5 2 4 3 8 OR 22 8
Replacement Parts List V50HYLD Item # Part Description 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 Top Panel Fan/Heater Assembly Synchronization Motor-120Volt AC w/Terminal Cord Power 16/3 HPN w/Terminals ON/OFF Switch Left Side Panel Right Side Panel Flame Generator Assembly Light Bulb Socket w/Wiring Assembly Door Door Pivot Door Knob Knob Dressing Legs Electrothermal Hood Back Panel Door Adorning Cross Band Air Transfer Panel Glistening Paper Part Number VL107-02F NFHTX186/VB17-000G VL051-01 N
REPLACEMENT PARTS PICTURES OF V50HYLD 5 3 2 9 4 8 OR 21 7 10