System information

10-11
Port Status and Basic Configuration
Viewing Port Status and Configuring Port Parameters
Displaying Loop Protection Status
To display information about ports with loop protection enabled, enter the
show loop-protect command.
For example:
Figure 10-4. Example of Show Loop-Protect Display
Using the CLI To Configure Ports
You can configure one or more of the following port parameters. For details
on each option, see Table 10-1 on page 10-4.
Syntax: [no] interface <[ethernet] port-list>
disable | enable
speed-duplex
<10-half |100-half | 10-full | 100-full | 1000-full | auto |
auto-10 | auto-100 | auto-1000 >
flow-control
Syntax: show loop-protect <port-list>
Displays the loop protection status. If no ports are specified, the
information is displayed only for the ports that have loop protec-
tion enabled.
ProCurve(config)# show loop-protect 1-4
Status and Counters - Loop Protection Information
Transmit Interval (sec) : 5
Port Disable Timer (sec) : 5
Loop Detected Trap : Enabled
Loop Loop Loop Time Rx Port
Port Protection Detected Count Since Last Loop Action Status
---- ----------- --------- ---------- ---------------- ------------ --------
1 Yes No 0 send-disable Up
2 Yes No 0 send-disable Up
3 Yes No 0 send-disable Up
4 Yes No 0 send-disable Up