System information

12-22
Port Trunking
Port Status and Configuration
Dynamic LACP Trunk Group: Appears in the output from the CLI show lacp
command.
Outbound Traffic Distribution Across Trunked Links
Both trunk group options (LACP and Trunk) use source-destination address
pairs (SA/DA) for distributing outbound traffic over trunked links.
SA/DA (source address/destination address) causes the switch to distribute
outbound traffic to the links within the trunk group on the basis of source/
destination address pairs. That is, the switch sends traffic from the same
source address to the same destination address through the same trunked link,
and sends traffic from the same source address to a different destination
address through a different link, depending on the rotation of path assign-
ments among the links in the trunk. Likewise, the switch distributes traffic for
the same destination address but from different source addresses through
different links. Because the amount of traffic coming from or going to various
nodes in a network can vary widely, it is possible for one link in a trunk group
to be fully utilized while others in the same trunk have unused bandwidth
capacity even though the address assignments are evenly distributed across
the links in a trunk. In actual networking environments, this is rarely a
problem. However, if it becomes a problem, you can use the ProCurve Man-
ager Plus network management software to quickly and easily identify the
sources of heavy traffic (top talkers) and make adjustments to improve
performance.
Interface Option Dynamic LACP
Trunk Group
Static LACP
Trunk Group
Static Non-Protocol
Trunk Group
Menu Interface No Yes Yes
CLI:
show trunk No Yes Yes
show interfaces No Yes Yes
show lacp Yes Yes No
show spanning-tree No Yes Yes
show igmp No Yes Yes
show config No Yes Yes