System information

13-26
Configuring for Network Management Applications
Using SNMP Tools To Manage the Switch
The show sflow agent command displays read-only switch agent information.
The version information shows the sFlow version, MIB support and software
versions; the agent address is typically the ip address of the first vlan config-
ured on the switch.
Figure 13-11. Example of Viewing sFlow Agent Information
The show sflow <instance> destination command includes information about
the management-station’s destination address, receiver port, and owner.
Figure 13-12. Example of Viewing sFlow Destination Information
Note the following details:
■ Destination Address remains blank unless it has been configured.
■ Datagrams Sent shows the number of datagrams sent by the switch
agent to the management station since the switch agent was last
enabled.
Displays status information about sFlow sampling and polling.
ProCurve# show sflow agent
Version 1.3;HP;K.12.XX
Agent Address 10.0.10.228
ProCurve# show sflow 2 destination
Destination Instance 2
sflow Enabled
Datagrams Sent 221
Destination Address 10.0.10.41
Receiver Port 6343
Owner Administrator, CLI-owned, Instance 2
Timeout (seconds) 99995530
Max Datagram Size 1400
Datagram Version Support 5