System information

13-44
Configuring for Network Management Applications
LLDP (Link-Layer Discovery Protocol)
For example, if you wanted to exclude the system name from the outbound
LLDP advertisements for all ports on a 2626 switch, you would use this
command:
ProCurve(config)# no lldp config 1-26 basicTlvEnable
system_name
If you later decided to reinstate the system name on ports 1-5, you would use
this command:
ProCurve(config)# lldp config 1-5 basicTlvEnable
system_name
Displaying Advertisement Data
Syntax [ no ] lldp config < port-list > basicTlvEnable < TLV-Type >
port_descr
For outbound LLDP advertisements, includes an
alphanumeric string describing the port.
system_name
For outbound LLDP advertisements, includes the system’s
assigned name.
system_descr
For outbound LLDP advertisements, includes an
alphanumeric string describing the full name and version
identification for the system’s hardware type, software
version, and networking application.
system_cap
For outbound advertisements, includes a bitmask of
system capabilities (device functions) that are supported.
Also includes information on whether the capabilities are
enabled.
Command Page
show lldp info local-device below
show lldp info remote-device 13-46
show lldp info stats 13-49