Installation Guide
NO-DIG
LANDSCAPE EDGING
®
INSTALLATION INSTRUCTIONS
Clear the installation area of
all grass, loose soil, mulch,
and debris. Place edging in
desired shape on cleared
surface with anchoring tabs*
facing the planting bed.
1 2
Use a rubber mallet to pound
anchoring spikes through the
tabs to secure the edging. Pull
the edging tight between
spikes.
3
Backll to the top of the
edging with mulch, river rock,
or other ground cover. Assure
tabs are completely covered
with a thick layer of bedding
material.
Always use proper safety precautions when cutting and spiking edging.
Cut edging at the midpoint
between the anchoring tabs using
hand snips or a ne tooth saw.
Cutting the Edging:
Site Preparation:
Soil must be solid and level. Assure there is
no debris between the landscape edging
tab and the dirt below. Compact the cleared
soil prior to installation to reduce spike
movement from shifting ground and frost
heave.
Weed fabric can minimize the spread of
invasive weeds and grass. If desired, install
fabric according to product directions. Then,
place the landscape edging over the fabric
and begin to hammer anchoring spikes
through the edging tabs and weed fabric.
Before installation, it is important to let the
edging relax in the sun to allow for thermal
expansion. Installing the edging when
expanded and pulling tightly can reduce
undesirable waves in straight installations.
Installation:
Certain conditions and landscape designs will require additional spikes,
which are available in stores and online.
Anchoring spikes should be inserted only to the top of the edging tab.
Installing the spike to the point the tab bends will result in wavy edging.
To connect edging ends, overlap the nal tab on each end and pound
spike through both holes.
Backll sufciently to the top of the edging immediately after installing the
edging. Heavy bedding materials, such as rock and mulch, tend to
perform best.
*Tab designs may vary.
HELPFUL TIPS & INFORMATION
INST-UNDIG-RV1
Marietta, OH 45750
Questions/Comments? Contact us at
customersupport@dimexcorp.com
INST-UNDIG-RV1