User`s manual
12
14. Apply a small amount of grease to the barrel of
an M6 x 72mm Shoulder Bolt (21).
H
ave another person hold the right Pedal Arm
(14) inside the bracket on the right Upper Body
L
eg (6).
Attach the right Pedal Arm (14) to the right
Upper Body Leg (6) with the M6 x 72mm
Shoulder Bolt (21), an M6 Washer (35), and an
M6 Locknut (77).
Repeat this step for the left side of the ellip-
tical exerciser.
See step 3. Tighten the four M10 x 20mm
Button Screws (79). Tip: Tighten the two
Button Screws on the front of the elliptical
exerciser before tightening the other two
Button Screws.
14
21
14
Grease
35
6
77
15. Identify the Right Inner Leg Cover (32) and the
Right Outer Leg Cover (30), which are marked
with “Right” stickers.
Attach the Right Inner Leg Cover (32) and the
Right Outer Leg Cover (30) around the right
Upper Body Leg (6) with three M4 x 16mm
Round Head Screws (84).
Repeat this step for the left side of the ellip-
tical exerciser.
15
32
30
84
84
6
16. Make sure that all parts of the elliptical exerciser are properly tightened. Note: Some hardware may be
left over after assembly is completed. To protect the floor or carpet from damage, place a mat under the
elliptical exerciser.