User`s manual

ASSEMBLY

Assembly requires two persons. Placeall partsof the ellipticalcrosstralnerin a cleared area and remove the

packingmaterials.Do notdisposeof the packingmaterialsuntilassemblyis completed. In addition to the

Included allen wrenches, assembly requlrss a phillips screwddver (_, an adjustable

wrench (_=_, and a rubber mallet C_) •

As you assemble the ellipticalcrosstreiner0usethe drawingsbelowto Identifythe smallparts used In assembly.

The number in parenthesisbeloweach drawingrefersto the key numberof the part,from the PARTLIST on

page 14. The secondnumberrefers to the quantify used in assembly.Note: Some small parts may have been

pre-aseemblad for shipping. If s part Is not In the parts bag, check to see If It has been pre-asserobled.

@8@@

M8 Nylon M10 Nylon M10 Splk Handlebar M10

Locknut(38)-4 Locknut (33)-6 Washer (45)-2 Washer(55)-2 Washer(29)-2

Console

Screw (59)-4 M8 x 19mm Button M10 x 27ram M10 x 27rom

Screw (56)-2 PatchScrew(40)-2 CarriageBolt(27)-2

Spdng Bracket

Washer (35)-2

M8 x 45mm ButtonBolt(50)-4

M10 BoltBet (25)-2

M10 x 74mro Bolt(7)-2

M10 x 75rom CarriageBolt(34)-4

1. Identifythe FrontStabilizer(10), whichhas round

Endceps(21) on it. While another parson lifts the front

of the Frame (1), attachthe FrontStabilizerto the

Frame withtwo MIO x 75mm Carriage Bolts(34) and

twoM10 NylonLocknuts (33).