User`s manual

6. Identifythe LeftHandlebar (6), whichismarkedwith a

sticker.Insertthe LeftHandlebar intoone of the

Handlebar Legs (5); make sure that the Handlebar

Leg Is turned so the hexagonal holes are on the

Indicated side. Attachthe Left Handlebarto the

Handlebar Leg with twoM8 x 45ramButtonBolts(50)

and two M8 NytonLocknuts(38). Make sure that the

Nylon Locknuts are Inside of the hexagonal holes.

Do not fully tighten the Button Bolts yet,

Applya smallamount of the includedgrease to the left

and right axleson the Updght(2).

Make surethat there are two Small Handlebar

Bushings(49) in the LeftHandlebar (6). Carefullyslide

an UprightSpacer(48), a HandlebarSpacer(47), the

LeftHandlebar,and a HandlebarCap (46) ontothe left

axleon the Upright(2) as shown.Slidea Handlebar

Washer(55) onto an M8 x 19ramButtonScrew(56), and

tightenthe ButtonScrewintotheaxle.

Assemblethe RightHandlebar (5) and the other

Handlebar Leg (5) inthe same way.

7. Identifythe left Pedal Spring (11), which is marked with

a sticker.Attach the Left Pedal (13) tothe leftPedal

Spdng withan M10 x 27mm Pedal Bolt(27), an M10

Washer (29), and a Pedal Knob(28) as shown,Note:

The Left Pedal can be attached in anyoffive positions

(see HOW TO ADJUST THE PEDALS on page 9).

Attachthe Right Pedal (not shown)In the same way.

Make surethat both Pedals are inthe same position,