User`s manual

8. Apply a smallamount of grease to the axleon the left
Disc Crossbar(16). Slidea Spdng Spacer (63) ontothe
axle;make sure that (he Spring Spacer ta turned so
the fiat aide Is facing the elliptical oroaatralner.
Next, slidethe LeftRear Spdng Bracket(12) on the left
Pedal Spdng (11) ontothe axle. Slidea SpringBracket
Washer (35) ontoan M10 x 27ram Patch Screw (40),
and tightenthe PatchScrew intothe axle.
Next, holdthe lowerend of the leftHandlebarLeg (5)
insideof the FrontSpdng Bracket(65) on the leftPedal
Spdng(11).Apply grease to an M10 BoltSet (25).
Attachthe Handlebar Leg tothe FrontSpdngBracket
withthe BoltSet. Do not overtlghtan the Bolt Sat;
the Handlebar Leg must pivot freely.
Attachthe dghtPedal Spdng (cot shown)to theright
side ofthe ellipticalcrosstralnerin the same way.
Refer tostep 5. Tightenthe M10 x 74ram Bolts(7) in
the Updght(2).
Refer to step6. Tighten the M8 x 45mm ButtonBolts
(50) in the Handlebar Legs (5).
7" 16
40 35
65
Grease
11
9. Make sure that all parts of the elliptical crosstrainer are propedy tightened. Note:Some hardwaremay
be leftover after assemblyis completed.To protectthe floor _ carpet fromdamage, place a mat underthe
ellipticalcrosstralner.
8