Manual

TROUBLESHOOTING
Inspect all parts of the vibration platform regularly. Replace any worn parts immediately. Outer surfaces of the vibra-
tion platform can be cleaned with a damp cloth and a mild, non-abrasive detergent; do not use solvents to clean
the vibration platform.
Most vibration platform problems can be solved by following the simple steps below. Find the symptom
that applies, and follow the steps listed. If further assistance is needed, call the telephone number listed
on the back cover of this manual.
PROBLEM: The power does not turn on
SOLUTION: a.
Make sure that the power cord is plugged into a surge suppressor, and that the surge suppres-
sor is plugged into a properly grounded outlet (see page 14). Use only a single-outlet surge sup-
pressor that meets all of the specifications described on page 14. IMPORTANT: The vibration
platform is not compatible with GFCl-equipped outlets.
b.
Check the reset/off circuit breaker located on the
vibration platform frame near the power cord. If
the switch protrudes as shown, the circuit breaker
has tripped. To reset the circuit breaker, wait for
five minutes and then press the switch back in.
PROBLEM: The power turns off during use
c
Tripped Reset
SOLUTION: a. Check the reset/off circuit breaker (see the drawing above). If the circuit breaker has tripped,
wait for five minutes and then press the switch back in.
b. Make sure that the power cord is plugged in. If the power cord is plugged in, unplug it, wait for
five minutes, and then plug it back in.
c. If the vibration platform still will not run, please see the back cover of this manual.
17