User's Manual

1. Make sure that the power cord is unplugged. Remove

the indicated Screws (A) from the Console Back (B).

Remove the Console Back from the Console Base (E).

2. Connect the included Short Jumper Wire (C) to the wire on

the Receiver (D). Connect the other end of the Short

Jumper Wire to the PULSE jack on the back of the

Console (see drawing 2b). If there is a wire already

plugged into the PULSE jack, unplug it. Next, peel the

paper off the pad on the back of the Receiver (D). Turn

the Receiver so the cylinder is on the side shown, hold

the Receiver inside of the Console Base (B), and press

the Receiver onto the bottom of the Console Base in the

location indicated by the dotted line. Note: The other wires

included with the receiver may be discarded. The Wire Tie

can be used to tie wires, if needed.

Make sure that no wires are pinched. See step 1.

Reattach the Console Back (B) with the Screws (A).

Cylinder

1. Make sure that the power cord is unplugged. Remove

the indicated Screws (A) from the Console Back (B).

Remove the Console Back from the Console Base (C).

2. Connect the included Long Jumper Wire (D) to the wire on

the Receiver (E). Feed the Long Jumper Wire through the

Console (F) as shown. Connect the other end of the Long

Jumper Wire to the PULSE jack on the back of the

Console. If there is a wire already plugged into the PULSE

jack, unplug it. Turn the Receiver so the cylinder is on

the side shown, and press the Receiver onto the back of

the Console Base (C) in the indicated location. Note: The

other wires included with the receiver may be discarded.

The Wire Tie can be used to tie wires, if needed.

Make sure that no wires are pinched. See step 1.

Reattach the Console Back (B) with the Screws (A).

PULSE

Jack

Cylinder

PULSE

Jack