User's Manual

1. Make sure that the power cord is unplugged. Remove

the indicated Screws (A) from the Console Back (B).

Remove the Console Back from the Console Base (C).

3. Connect the included Long Jumper Wire (E) to the

PULSE jack on the back of the Console (F). If there is a

wire already plugged into the PULSE jack, unplug it.

Feed the Long Jumper Wire into the hole in the side of

the Console Base (C).

4. Connect the Long Jumper Wire (E) to the wire on the

Receiver (G). Next, peel the paper off the pad on the

back of the Receiver. Turn the Receiver so the cylinder

is on the side shown, and press the Receiver onto the

back of the Console Base (C) in the indicated location.

Note: The other wires included with the receiver may be

discarded. The Wire Tie can be used to tie wires, if

needed.

Make sure that no wires are pinched. See steps 3, 2,

and 1. Reattach the Console (F) and the Console Back

(B).

2. Have a second person hold the Console Base (C) as you

remove the indicated Screws (D) from the Console Base.

PULSE Jack

Cylinder

Hole