User's Manual

PULSE 2 Jack

These instructions are to be used with a treadmill that has a

TV and resembles the treadmill shown in the drawings at the

right.

1. Make sure that the power cord is unplugged. Remove

the indicated Screws from the Console Back (A).

Important: The Screws may be different lengths. Keep

track of which Screws were removed from which holes.

2. Raise the Console (C) enough to view the back of the

Console. Peel the paper off the pad on the bottom of the

Receiver (B). Turn the Receiver so the cylinder is on

the side shown, and press the Receiver onto the back of

the Console in the indicated location.

3. Connect the included Short Jumper Wire (D) to the wire

on the Receiver (B). Connect the other end of the Short

Jumper Wire to the PULSE 2 jack on the back of the

Console (C). If there is a wire already plugged into the

PULSE 2 jack, unplug it. Note: The other wires included

with the receiver may be discarded. The Wire Tie can be

used to tie wires, if needed.

Make sure that no wires are pinched. See step 1.

Reattach the Console (C) with the Screws. Important: If

the Screws are not put back into the same holes from

which they were removed, the Console will be dam-

aged.

Screws

PULSE #2

2, 3

Cylinder