Instructions / Assembly

30
MAINTENANCE
Inspect and tighten all parts of the exercise bike
regularly. Replace any worn parts immediately.
To clean the exercise bike, use a damp cloth and a
small amount of mild soap. IMPORTANT: To avoid
damage to the console, keep liquids away from
the console and keep the console out of direct
sunlight.
CONSOLE TROUBLESHOOTING
If the console does not turn on, make sure that the
power adapter is fully plugged in.
If the console does not display your heart rate when
you use the handgrip heart rate monitor, see step 5 on
page 19.
If it is difficult for you to touch the correct buttons on
the screen, the screen may not be properly calibrated.
To calibrate the screen, see step 4 on page 26.
If a replacement power adapter is needed, call the
telephone number on the cover of this manual.
IMPORTANT: To avoid damaging the console, use
only a manufacturer-supplied regulated power
adapter.
HOW TO ADJUST THE DRIVE BELT
If the pedals slip while you are pedaling, even while the
resistance is adjusted to the highest setting, the drive
belt may need to be adjusted. Before you adjust the
drive belt, unplug the power adapter.
See assembly step 11 on page 12. Using
an adjustable wrench, remove the Right Pedal
(21). IMPORTANT: Turn the Right Pedal
counterclockwise to remove it; turn the Right Pedal
clockwise to attach it.
See assembly step 10 on page 12. Remove
the Seat Post (6). Then, loosen the Seat Post Knob
(27), pull it outward, and use an adjustable wrench to
remove it.
See EXPLODED DRAWING B on page 35. Using
a standard screwdriver, release the Front Shield Cover
(9) and slide it out of the way.
Remove the two #8 x 16mm Screws (34) from the Rear
Shield Cover (7). Then, use a standard screwdriver to
remove the Rear Shield Cover.
Remove the twelve #8 x 16mm Screws (34) and the
two M4 x 22mm Screws (84) from the Right and Left
Shields (10, 11). Then, remove the Right Shield.
Locate and loosen the M6 x 20mm Screw (48). Next,
tighten the M10 x 65mm Screw (51) until the Drive Belt
(54) is tight. Then, retighten the M6 x 20mm Screw.
Reattach all the parts that you removed and plug in the
power adapter.
MAINTENANCE AND TROUBLESHOOTING
48
51
54