Instructions / Assembly

MAINTENANCE

Regular maintenance is important for optimal

performance and to reduce wear. Inspect and properly

tighten all parts each time the rower is used. Replace

any worn parts immediately.

To clean the rower, use a damp cloth and a small

amount of mild detergent. IMPORTANT: To avoid

damage to the console, keep liquids away from

the console and keep the console out of direct

sunlight.

For best results, clean the rail, the seat carriage, and

the carriage rollers daily.

CONSOLE TROUBLESHOOTING

Most console problems are the result of low batteries;

for replacement instructions, see assembly step 6 on

page 8.

HOW TO ADJUST THE REED SWITCH

If the console does not display correct feedback, the

reed switch should be adjusted.

To adjust the reed switch, you must remove the

resistance handle and the right and left shields as

described below.

First, remove the

six M4 x 10mm

Screws (70),

and then gen-

tly remove the

Resistance

Handle (9).

See the EXPLODED DRAWING on page 19.

Locate the Right and Left Shields (7, 8), and remove

the four M4 x 19mm Screws (69) and the ten M4 x

16mm Screws (68) from the Right and Left Shields.

Then, gently remove the Right and Left Shields.

Locate the Reed Switch (47). Turn the Left Fan (4) until

a Magnet (77) is aligned with the Reed Switch. Slightly

loosen the two indicated M4 x 19mm Screws (69).

Then, slide the Reed Switch slightly closer to or away

from the Magnet, and retighten the Screws.

Turn the Left Fan (4) so that the Magnet (77) passes

the Reed Switch (47) repeatedly. Repeat these actions

until the console displays correct feedback.

When the reed switch is correctly adjusted, reattach

the parts that you removed.

MAINTENANCE AND TROUBLESHOOTING