Installation Guide
7.
Installing the
Decorative Cover
CAUTION: Before starting installation,
disconnect the power by turning off the circuit
breaker or removing the fuse at fuse box. Turning
power off using the fan switch is not sufficient to
prevent electric shock.
Remove the 1 of 3 screws from the posts of
the mounting ring and keep it for future use.
Loosen the other 2 screws. (Do not remove)
Place the key holes in the
decorative cover
over the two screws previously loosened from
the mounting ring. Turn the
decorative cover
until the decorative cover locks in place at the
narrow section of the key holes. (Fig. 13)
Securely tighten the two mounting screws
previously loosened and the one previously
removed.
Fit the decorative cap onto the decorative
cover and secure with the nut provided.
Re-Install the bottom guard back to the
fan
guard.
Screws
Screws
Bottom Guard
Decorativ Cap
Nut
Decorative Cover
Mounting Ring
Figure 13
1.
2.
3.
4.
5.
Installing the battery
Install 12V battery (included), to prevent damage
to transmitter, remove the battery if not used for
long periods. (Fig. 14)
Figure 14