Installation Guide

9. Installing the Light Kit and Glass Shade
CAUTION: Before starting installation,
disconnect the power by turning off the circuit
breaker or removing the fuse at fuse box. Turning
power off using the fan switch is not sufficient to
prevent electric shock.
Step 1. Remove 1 of 3 screws from the posts of
the
glass frame assembly and keep it for future
use. Loosen the other 2 screws. (Do not remove)
Step 2. While holding the light kit under your
fan, make the polarized plug connections: (Fig.
16)
- White to white
- Blue to black
Step 3. Place the key holes in the light kit over
the two screws previously loosened from the
glass frame assembly . Turn the light kit until the
light kit locks in place at the narrow section of
the key holes. (Fig. 16)
Step 4. Securely tighten the two mounting screws
previously loosened and the one previously
removed.
Step 5. Raise glass shade up against the light kit
and secure it to fan by turning glass clockwise
until snug. DO NOT OVERTIGHTEN.
(Fig. 17)
Step 6. Install 2 x 7W LED bulbs (included).
Figure 16
Figure 17
Screws
Light kit
Wire connectors
Glass frame
assembly
Glass
shade
Light kit
Bulbs