Operation Manual

the Multitab indicator light comes on. This
means that the function is active.
To deactivate the function press the same
buttons again until the indicator light corre-
sponding to the Multitab function symbol
goes off.
If the drying results are not satisfac-
tory we suggest that you:
1. Fill up the rinse aid dispenser with
rinse aid.
2. Activate the rinse aid dispenser.
3. Set the rinse aid dosage to position
2.
• The activation/deactivation of the
rinse aid is only possible with the Mul-
titab function active.
Activation/deactivation of the rinse aid
dispenser
1. Press the On/Off button. The dishwasher
must be in setting mode.
2. Simultaneously press and hold function
buttons B and C, until the lights of func-
tion buttons A , B, and C start flashing.
3. Press function button B, the lights of
function buttons A and C go off while the
light of function button B continues to
flash.
4. To activate the rinse aid dispenser, press
button B again, the End indicator light
comes on, indicating that the rinse aid
dispenser has been activated.
5. To memorize the operation, switch off the
dishwasher by pressing the On/Off but-
ton.
6. To deactivate the rinse aid dispenser
again, follow the above instructions until
the End indicator light goes off.
If you decide to revert back to the
use of individual detergents we ad-
vise that you:
1. Deactivate the Multi-tab function.
2. Fill up the salt container and the rinse
aid dispenser again.
3. Adjust the water hardness setting to
the highest setting and perform 1
normal washing programme without
loading any dishes.
4. Adjust the water hardness setting
according to the hardness of the wa-
ter in your area.
5. Adjust the rinse aid dosage.
Select and start a washing programme
Select the washing programme with
the door slightly opened. The start of
the programme will occur only after
the closure of the door. Until then it
is possible to modify the settings
1. Check that the baskets have been loaded
correctly and that the spray arms are free
to rotate.
2. Check that the water tap is opened.
3. Press the On/Off button. The dishwasher
must be in setting mode.
4. Press the button corresponding to the re-
quired programme (see ''Washing pro-
grammes'' chart).
When a programme has been selected
the corresponding light comes on.
The phase indicator lights foreseen for
the set programme start flashing.
Close the dishwasher door, the pro-
gramme starts automatically.
Once the programme starts, the phase
indicator lights go off except for the indi-
cator light of the phase in progress which
will remain on with a static light.
Setting and starting the programme with
delay start
1. After having selected the washing pro-
gramme, press the delay start button until
the light corresponding to the chosen
hours flashes (3h, 6h or 9h).
2. Close the dishwasher door, the count-
down starts automatically.
3. The countdown will decrease with steps
of 3 hours.
4. The opening of the door will interrupt the
countdown. Close the door; the count-
down will continue from the point at
which it was interrupted.
5. Once the delay start has elapsed the pro-
gramme will start automatically.
Once the countdown of the delay start
has elapsed, the washing programme
will start automatically.
80 progress