Owner manual

C2000

Program & Report

‚ 17

Mode Descriptions

The sequence for manager access

must

be completed before

programming features can be utilized through the various program

modes. The sequence for either manager access or operator access

allows generation of reports (Modes 10, 11 and 12). Each set of

instructions for the following program and report modes assumes

that the appropriate manager/operator access has already been

executed and that the

mode number

prompt now appears in the

display.

Mode 1 — Pump Setup Information

(Manager only)

Through Mode 1, assignments, blend ratios and self/full service

modes are entered for each pump/fueling position controlled by

the C2000. After being prompted for

mode number

(see

previous page for instructions on accessing program mode),

press

<1>

on the numeric keypad and then press

<ENTER>

You are now in Mode 1.

Initiate pump programming by pressing the

key

for the first pump/fueling position at the site (usually Pump #1).

The mode begins with setting the following parameters for hose

1. (If you have a multi-product dispenser, then you will need to

set these for all hoses.) Press the

<GRADE>

key to scroll to

the desired product for the current hose displayed. During this

step, pressing the

key will clear the product

number for reentry.