Owner manual

C2000
Program & Report
‚ 26
Special editing features are available for use in this mode:
<ENTER>
without entering a numeric code — The display
curser will increment to the next character in the header.
<SELECT>
without entering a numeric code — The display
curser will go back one character in the header.
<CHANGE>
without entering a numeric code — The entire
printer header will be cleared.
<PRINT>
without entering a numeric code — The printer will
print the header that is programmed.
<MANAGER>
— Exit Mode 7.
Mode 10 — Read Reports
(Manager/Operator)
In Mode 10, totals reports may be generated and displayed. To
enter this mode, enter
<10>
on the keypad and press
<ENTER>
.
The display will show an
R:0
, prompting you to enter a report
type code. Use the table below to select which type of report
you would like displayed.
1
Resettable Totals
2
Non-Resettable Totals
3
Shift 0 Totals (current shift)
4
Shift 1 Totals
5
Shift 2 Totals
6
Shift 3 Totals
7
Polled Pump Totals