Installation Guide

5. Tighten the track mounting screws (A) to secure

the track section (F) to the mounting plate (B ).

6. Twist the twist-lock connector (C) into the track

section (F). Secure the canopy (D) to the

mounting plate (B) by tightening the previously

removed canopy screws (E).

Note: When the twist-lock connector (C) is twisted

into position on the track section (F), make sure

the two copper tabs on the side of the twist-lock

connector (C) align with the two copper strips inside

the track section (F). This is necessary to

maintain polarity.

b. For anchor installation, drill a 7/32 in. hole at each

mark on the ceiling, and insert anchors (CC) into

the mounting surface. Insert the Phillips screws

(BB) through the track section (F) and tighten to

anchors (CC).

NOTE: Toggle bolts (AA) should be used for standard installation into drywall, drop ceiling or

suspended ceiling applications. Anchors (CC) are used for masonry installations ONLY.

Hardware Used

x 2

Phillips Screw

x 2

Anchor

Lowes.com