2 VOLT SOLAR PANEL KITS MONOCRYSTALLINE P/No.
WARNING SOLAR PANEL • For installations with lead acid batteries, avoid sparks or flames near the batteries and always use proper eye protection • Given sufficient light, solar panels always generate energy even when they are disconnected • Accidental ‘shorting’ of the terminals or wiring can result in sparks causing personal injury or a fire hazard • Do not scratch or bend solar panels • Do not disassemble the solar panel • When mounting solar panels at a height adhere to all relevant safety regulations •
SPECIFICATIONS P/No. TYPE RATED POWER OPEN CIRCUIT VOLTAGE SHORT CIRCUIT CURRENT PEAK POWER VOLTAGE PEAK POWER CURRENT TEST CONDITIONS BATTERY CONNECTIONS SPP120K MONOCRYSTALLINE 120W 21.0V 7.5A 18.0V 6.87A 1000W/m2, 25˚C Battery Clamps SOLAR CONTROLLER 3 Stage Charging – Built in regulator to prevent your battery from being overcharged. Overcharging occurs when the charge voltage is unregulated. This can result in premature battery failure.
CHARGING STAGES Bulk Charge (Level 1) – Maximum current charging until batteries rise to Absorption level Absorption Charge (Level 2) – Constant voltage charging and battery is over 85%. Equalization Charge* (Level 3) – Only for WET battery or Calcium battery type, when the battery is deeply drained below 10V, it will automatically run this stage to bring the internal cells as an equal states and fully complement the loss of capacity.
SOLAR CONTROLLER SPECIFICATIONS TYPE INPUT MAXIMUM INPUT BATTERY ABSORPTION EQUALISATION FLOAT START APPROVALS BATTERY SIZES 3 Stage Automatic 12V Solar Panels 25V 12V 14.4V 14.8V (When voltage drops below 11.1V) 13.7V 9V EMC 250–1200CCA 300–1500MCA 40–200Ah INSTALLATION & CONNECTION STEP 1 Locate the panel in the best position Locate the panel in a position where it is exposed to the sun for the majority of the day. For best results use a northern orientation.
FREQUENTLY ASKED QUESTIONS Q. Can the solar panel be mounted on a flat roof or wall? A. Yes. It is fine to mount the panel on a horizontal surface such as a roof or on a vertical surface like a wall as long as the panel receives full sun for a reasonable period of the day. You will however gain better performance if the panel is tilted toward the sun and faced in a northerly direction, since this enables the maximum amount of solar energy to reach the panel. Q. What current output can I expect? A.
NOTES 7
WARRANTY STATEMENT Applicable only to product sold in Australia Brown & Watson International Pty Ltd of 1500 Ferntree Gully Road, Knoxfield, Vic.
