Operation Manual

Getting Started
Using the remote control
When using the remote control, aim it at the remote sensor on the television. If there is
an object between the remote control and the remote sensor on the unit, the unit may
no operate.
 Point the remote control at the REMOTE SENSOR located on the television.
 When using this television in a very brightly lit area, the infrared REMOTE CONTROL
SENSOR may not work properly.
 The maximum effective distance for using the remote control is about 7 metres.
Installing Batteries in the Remote Control
1. Slide back the battery cover of the remote control.
2. Install two AAA size batteries(not supplied). Observe
the correct polarity (+/-) when inserting the batteries.
3. Replace the cover.
Battery replacement
When the batteries become weak, the operating distance of the remote control will be
greatly reduced and you will need to replace the batteries.
Notes on Using Batteries:
The use of the wrong type of batteries may cause chemical leakage and/or explosion.
Please note the following:
 Always ensure that the batteries are inserted with the + and - terminals in the correct
direction as shown in the battery compartment.
 Different types of batteries have different characteristics. Do not mix different types.
 Do not mix old and new batteries. Mixing old and new batteries will shorten battery
life and/or cause chemical leakage.
 Replace batteries as soon as they do not work.
 Chemicals which leak from batteries may cause skin irritation. If any chemical matter
seeps out of the batteries, wipe it up immediately with a dry cloth.
 The batteries may have a shorter life expectancy due to storage conditions. Remove
the batteries whenever you anticipate that the remote control will not be used for a
long time.
 The batteries (battery pack or batteries installed) shall not be exposed to excessive
heat such as sunshine, fire or the like.
10
Downloaded from www.vandenborre.be