Operation Manual

Connection and setup

Cable Installation

Please read this section carefully before installation and use.

reach the ambient room temperature before you connect it to the mains.

NOTE:

 When you plug or unplug the TV, computer or other equipments, you must make

sure that the AC power has been already shut down; when unplugging the power

cable or signal cable, please hold the plug (the insulated part), do not pull the cable.

2. The RF output terminal can be connected with the RF input port of the TV.

NOTE:

 Component and AV inputs cannot be used at the same time since they share one

single audio input.

4. The output COMPONENT (YPbPr) terminal of DVD can be connected with the

COMPONENT (YPbPr) input port of the TV through AV cable.

NOTE:

 Please do not force to connect the 15-pin VGA.

the HDMI cable with the HDMI port on the TV.

NOTE:

 Please do not force to connect the HDMI.

7. Connect the TV set with an external device using the SCART socket.

9. Check and make sure that all AV cables are connected with the corresponding ports

correctly.

NOTE:

 The range of power input for the TV is 100-240V~ 50/60Hz, do not connect the TV

power input port with the AC power out of the above range.

 Please hold the insulated part of the plug when you are unplugging the power

cable, do not touch directly the metallic part of the cable.

When you connect a HDMI cable through a VGA or DVI/HDMI adaptor,

you have to connect a PC/DVI audio cable to get sound.

1. Take out the TV from the package and put it on a stable surface. Allow the TV set to

through AV cable.

3. The output AV terminal of DVD can be connected with the AV input port of the TV

5. Connect one end of the VGA cable with the VGA port on computer, connect the other

end of the VGA cable with the VGA port (PC) on the TV, and tighten the

boltclockwise son each end of VGA cable.

6. Connect one end of the HDMI cable with HDMI output port, connect the other end of

8. Send the TV's audio signal to external audio equipment via the Digital Audio

10. Connect the AC power cable with 100-240V~ power supply.

Output

port.

 If COMPONENT (YPbPr) and AV works as mini terminal,and shared same audio,

please choose to use a one-to-three audio&video cable.

Downloaded from www.vandenborre.be