Owner's manual

18
2.3.3 How to configure router
This equipment provide 3 working mode for different usage, in order to
set proper parameter in each function/mode, you can follow this flow chart
before you start to configure router.
START power on ROUTER
I connect LAN cable to PC
I setting PC environment
I (Chapter 3,4)
I
LOG ON .UN=admin, PW=admin
I (Chapter 5-1,5-2)
I
Click select working mode
WORK MODE default is Gateway mode
I (Chapter 5-3)
I
I
SELECT MODE ROUTER will reboot after
I select
I
_______________________________________________
Gateway Basic NAT Router
________I________________ _ I _ _I_
I I I I I
Access Bandwidth Advance Advance Advance
Control Control
---- Remote Config Remote Config --
Local IP Filtering Virtual server Virtual server
Remote IP Filtering DMZ Host DMZ Host
Dos Defense Multi-NAT Multi-NAT
Load Balance Load Balance
DDNS DDNS
Proxy Proxy
Mail Alert Mail Alert
Time Time Time
System Log System Log System Log
Mac address Mac address .Mac address
Clone Clone Clone
IP Binding IP Binding
I
I
_____________________________________________________________________
System Configure WAN Administration F/W Update
Status LAN & DHCP Configuration
I
I
I
SAVE & RESET