Owner's manual

5.11.4 Multi-NAT

Multi-NAT function allow you to configure multiple LAN IP

Domain to each WAN port( total 10 LAN IP can be defined), after configure multiple

NAT function It will act like have virtual router connect to Broadband Router LAN

port, all traffic between each LAN IP domain , will send and receive through

broadband router. it will provide following benefit .

.* restrict broadcast storm in single IP domain.

.* Broadband router can check each packet with DoS function enable.

LAN IP: separated LAN IP domain.

Subnet Mask: mask for IP domain.

WAN IP: specific WAN IP address that match to LAN IP domain.

You can leave blank in this field for PPPoE connection/

Or write down specific WAN IP address, if WAN port had

Define multiple IP address on it (DMZ used)

Blank: router will send packet follow by WAN filed selected .

WAN: WAN1, WAN2, AUTO

WAN1/2/3/4 …router will route packet to correspond LAN/WAN

AUTO……….router will route packet follow by “load balance”

Function selected

MULTI-NAT