User Manual User Manual

PROLiNK® WNR1008 www.prolink2u.com
Version 1.00 40 English
4. Cancel the pop-up "Location Information" screen.
5. Click Next on the "New Connection Wizard" screen.
6. Select "Connect to the Internet" and click Next.
7. Select "Set up my connection manually" and click Next.
8. Check "Connect using a broadband connection that is always on" and click Next.
9. Click Finish to close the New Connection Wizard Setup is now completed.
For Windows Vista
1. Select Start menu  Control Panel  Network and Internet  Network and Sharing Center.
2. Select Set up a connection or network.
3. Select Connect to the Internet and click Next to continue.
4. Select Broadband (PPPoE).
5. Enter User name and Password that provided by the ISP, then click Connect to make a connection.
For Windows 7
1. Select Start menu  Control Panel  Network Sharing Center.
2. Select Set up a new connection or network.
3. Select Connect to the Internet and click Next to continue.
4. Select Broadband (PPPoE).
5. Enter User name and Password that provided by the ISP, then click Connect to make a connection.
Accessing AOL
To access AOL (America On Line) through the Wireless Router, the AOL for Windows software must be configured to
use TCP/IP network access, rather than a dial-up connection. The configuration process is as follows:
1. Start the AOL for Windows communication software. Ensure that it is Version 2.5, 3.0 or later. This procedure
will not work with earlier versions.
2. Click the Setup button.
3. Select Create Location, and change the location name from "New Locality" to " Wireless Router ".
4. Click Edit Location. Select TCP/IP for the Network field. (Leave the Phone Number blank.)
5. Click Save, then OK.
6. Configuration is now complete.
7. Before clicking "Sign On", always ensure that you are using the " Wireless Router " location.
4.3.
From your Macintosh, you can access the Internet via the Wireless Router. The procedure is as follows.
1. Open the TCP/IP Control Panel.
2. Select Ethernet from the Connect via pop-up menu.
3. Select Using DHCP Server from the Configure pop-up menu. The DHCP Client ID field can be left blank.
4. Close the TCP/IP panel, saving your settings.
If using manually assigned IP addresses instead of DHCP, the required changes are:
 Set the Router Address field to the Wireless Router's IP Address.
 Ensure your DNS settings are correct.