USER MANUAL FASTTRAKS 150TX2

Chapter 2: Getting Started

Gigabyte Boundary

The Gigabyte Boundary feature is designed for mirrored arrays (RAID 1 or RAID

0+1) in which a drive has failed and the user cannot replace the drive with the

same capacity or larger. Instead, the Gigabyte Boundary feature permits the

installation of a replacement drive that is slightly smaller (within 1 gigabyte) than

the remaining working drive (for example, an 80.5 GB drive would be rounded

down to 80 GB).

This can be helpful in the event that a drive fails and an exact replacement

model is no longer available. Without this feature enabled, FastTrak S150

TX2plus will NOT permit the use of a replacement drive that is slightly smaller

than the remaining working drive.

For the Gigabyte Boundary feature to work, the Gigabyte Boundary feature must

be set to ON when the original mirrored array is created. When enabled, the

Gigabyte Boundary feature rounds the drive capacity of both drives to the

common whole GB drive size. For example, with the Gigabyte Boundary feature

enabled, the remaining working drive can be 80.5 GB and the replacement drive

can be 80.3, since both are rounded down to 80GB.

This permits the smaller drive to be used. Please note that users will lose a

small amount of available storage capacity from both drives in order to arrive at

a common drive size.

Note

Gigabyte Boundary is automatically disabled when creating

a mirrored array (RAID 1) from an existing drive (versus

using two brand new drives). This protects the existing

drive’s partition table in order to maintain data integrity.