User's Manual

SuperTrak EX Series User Manual
210
-p <port number> Subsystems only. Specifies the port number of the TFTP
server.
If no port number is given, the default value of 69 is used.
Examples
ptiflash -f fw_multi_20051022.img[for SuperTrak controllers]
ptiflash -t -s 192.168.1.1 -f fw_multi_20031010.img -p 69[for embedded
Subsystems]
ptiflash -f fw_multi_20031010.img[for in-band Subsystems]
rc
Usage
rc [-a <action>] [-l <LdId>]
rc -a start -l <LdId> [-n] [-p]
rc -a stop -l <LdId>
rc -a pause -l <LdId>
rc -a resume -l <LdId>
Summary
Th rc command starts, stops, pauses and resumes a Redundancy Check and
monitors the progress of a running Redundancy Check.
Options
-a <action> Specifies action to perform.
list (Default) Displays active and paused Redundancy
Checks and their status.
start Starts a Redundancy Check.
stop Stops a Redundancy Check.
pause Pauses a Redundancy Check.
resume Resumes a paused Redundancy Check.
-l <Ld ID> Specifies the logical drive ID on which to run the
Redundancy Check.
-n Do not fix inconsistent data. This option causes
Redundancy Check to run without correcting inconsistent
data. All inconsistency errors are reported.
-p Pause on error. This option causes Redundancy Check
to pause when it encounters inconsistent data. The
default is to continue on error.