User's Manual
257
Chapter 8: Troubleshooting
• Problem Reports from SuperTrak
• Buzzer (page 257)
• LEDs (page 257)
•BIOS (page259)
• Problems Reported in WebPAM PRO (page 261)
• Critical & Offline Logical Drives (page 263)
• Salvaging Physical Drives (page 265)
• Rebuilding a Logical Drive (page 266)
• Recovering from a Blank Screen (page 268)
Problems Reported by SuperTrak
The SuperTrak EX Controller provides both audible and visual indicators to alert
you to a problem.
Buzzer
The buzzer sounds to inform you that your RAID system needs attention. But the
buzzer does not specify the condition. When a continuous tone sounds, there are
multiple alarm patterns sounding at the same time.
When the buzzer sounds, take the following actions:
• Check your disk arrays and logical drives.
• Check the Event Log. See page 101 or page 113.
LEDs
If your system is configured with Global LEDs or Direct LEDs, they will indicate
when a problem is present. Use the SuperBuild utility or WebPAM PRO to further
diagnose and correct the problem.