User's Manual

SuperTrak EX Series User Manual
290
10. Replace the screw holding the SuperTrak EX Controller card to the system
case.
11. Attach the SAS multi-lane cables to the SuperTrak EX Controller card.
12. Replace the cover of your system.
13. Power-up the system and launch WebPAM PRO.
See “Logging into WebPAM PRO” on page 107.
After installation and power-up, a new battery takes several hours to charge.
From that time, it should show Fully Charged. See “Viewing Battery Information”
on page 142.
The BBU module is covered by a one-year warranty. See “Limited Warranty” on
page 276.