User's Manual

Chapter 2: Installation
23
Installing the CLI
The Command Line Interface (CLI) provides rapid setup of disk arrays and logical
drives. You can also manage your SuperTrak system using the CLI.
Installing onto Windows
To install the CLI onto your Windows PC or server:
1. Boot the PC or server, launch Windows, and log in as the Administrator.
If the computer is already running, exit all programs. If you are not logged in
as the Administrator, log out, then log in again as the Administrator.
2. Insert the Software CD into your CD-ROM drive.
The installer window opens automatically.
3. Click the CLI/SNMP button, then click the Install CLI for Windows button.
The first CLI installation dialog box appears.
4. In the Introduction dialog box, click the Next button to proceed with
installation.
Figure 12. Introduction dialog box
The CLI uses the same installer as WebPAM PRO. Even though the dialog
boxes say “WebPAM PRO,” this procedure installs the CLI.