Product Manual (Installation and Assembly)

Page 15
Assembly
Read and understand all assembly instructions before beginning the assembly process.
This trampoline should not be installed without the included enclosure safety net.
Step 1 – Unfold and lay the jumping mat (jumping surface) on the ground inside the
trampoline frame circle. Make sure the warning labels are facing up.
Step 2 – Hook the jumping mat to the frame by attaching one spring to the right of each t-
bracket (see illustration below). To attach a spring, hook the short end to a v-ring sewn to
the jumping mat and pull the spring back towards the frame using the included spring puller.
Insert the long end of the spring into a slot in the frame and then release the spring. You will
need to count the number of slots between t-brackets so that you can find the corresponding
v-ring on the jumping mat to attach the next spring.
Caution: Be careful where you place your hands as the spring and frame joints can
pinch. We recommend wearing leather gloves while attaching the springs.
Note: DO NOT attach all of the springs in this step.
Only attach the springs to the right of each t-bracket
Step 3 – Unfold the enclosure netting. Locate the zipper opening and ensure that the warning
labels are facing outwards.