Product Manual (Installation and Assembly)

Page 17
Step 7 – Your enclosure net should now be hanging loosely from the enclosure poles with
the zippered opening centered between two enclosure poles. Straighten out any areas where
the enclosure netting appears to be bunched up.
Step 8 – Now starting on the left side of the t-bracket feed the short end of a new spring
through the enclosure net near the bottom edge and attach it to the v-ring (as shown in figure
1 below). Now pull the spring back towards the frame using the included spring puller and
insert the long end into the corresponding slot of the frame. You should now have a spring
on each side of the t-braket. One on the left attached to the enclosure net and jumping mat,
and the other on the right attached to the jumping mat (as shown in figure 2).
Figure 1 Figure 2
Repeat this process by working your way around the trampoline attaching one spring to the
left of each t-bracket.
As you work around the trampoline ensure that the enclosure netting is evenly stretched and
that there is no bunching of the net in between springs.
Step 9 – You should now have one spring connected on both sides of each t-bracket (as shown
in the picture below).
One spring attached through the enclosure netting and the
other spring still attached directly to the jumping mat.