Product Manual (Installation and Assembly)

Page 22
StormRider Trampoline Anchor Kit
Trampolines, especially those with enclosure nets can be blown and
severely damaged by wind. It is highly recommended that you secure your
trampoline against the wind. Some trampoline models include one of our
StormRider Anchor Kits; if so, please follow the instructions on this page
to install it correctly. More information about this anchor kit and a
selection of other accessories may be found on page 28. Anchor kits may
also be purchased online at www.PropelTrampolines.com.
Step 1- Evenly space the stakes around the perimeter of your trampoline.
Step 2- Using a rubber mallet, pound each stake at a 45 degree angle into
the ground until it is flush with ground level.
Step 3- Secure the straps to the frame of the trampoline by looping the
strap over the frame and following back through the ladder locks. Then
take the strap and loop it through the lower ladder lock. See illustrations below.
NOTE: To ensure the effectiveness of your anchor kit, keep Straps tight at all times.
This completes the installation of your StormRider Anchor Kit.
Warning: The installation and use of an anchor kit does not guarantee that your trampoline will not be damaged by wind or other severe
weather. Many factors such as soil types influence the effectiveness of this product. If using this product in sandy, loose soil, or in a
high wind area it is recommended that you purchase and use two anchor kits. You may have to take other precautions such as,
disassembling your trampoline during times of severe weather. Using an anchor kit is not an insurance policy and will not add additional
warranty benefits to your trampoline. Propel Trampolines and its retailers/affiliates will not be held responsible for damages to persons
or property as a result of the failure of this product.