Full Product Manual

6 ProTeam
ASSEMBLY (Continued)
DRUM/CADDY (Continued)
8. Insert the caster stem into the socket
of the caster foot as shown. (Front
casters only).
9. Push on the caster until the ball on
the caster stem is inserted all the way
into the socket. You will be able to
hear the ball snap into the socket
and the caster will swivel easily when
positioning is correct.
10. Install (4) #10 x 1-3/4" screws into
matching holes on both right and left
side of caddy, securing the caddies
to the bottom of the drum. Tighten
screws until just snug. DO NOT
over tighten the screws, as this may
deform the caddies.
Press and hold release buttons while
installing handle into handle receptacles
in drum (See illustration).
NOTE: An audible snap of release buttons
indicates successful engagement of
handle.
INSTALLING HANDLE
Press and hold release buttons as shown.
While firmly pushing in release buttons,
pull handle upwards to remove (see
illustration).
REMOVING HANDLE
Socket
Caster Stem
Caster Ball
Caster (2)
#10 x 1-3/4"
Screw (4)