Full Product Manual

ProTeam 7
ASSEMBLY (Continued)
Tote Snaps
Tote
Straps (4)
Handle
Extension
Wand
Storage
Locations
Wall
Grommet
Wall Mount
Hook
(Not Included)
1. Install tool holder as shown with exten-
sion wand holders (not included on all
models) facing unit.
2. As an alternative storage solution, the
tool holder may hang on a wall. Two
wall mounting hooks (not included)
must be secured to the wall as shown
(sold separately).
INSTALLING TOOL HOLDER
WET/DRY VACUUM ASSEMBLY
1. Position the powerhead assembly on
the drum/caddy assembly as shown
(assembled earlier).
2. Rotate both latches down and press
until you hear them snap over the
flanges on the drum.
Drum
Latch
Drum
Latch
Drum
Flange
Latch
Drum
Powerhead
Assembly
Insert Hose
Insert the push button end of the hose
into the inlet of the Vacuum. The hose
should snap into place.
To remove the hose from the Vacuum,
press the release button in the hose
assembly and pull the hose out of the
Vacuum inlet, as shown.
Press the curved metal extension wand
into the coupling ring of the hose end.
Join the two metal extension wands,
aligning the button and hole so they snap
together.
Attach the accessories, aligning the
button and hole so they snap together.
Release
Button
Press
and
Pull
Coupling
Ring
Accessory
Metal
Extension
Wand
(Curved)
Metal
Extension
Wand
(Straight)
Wet/Dry Vac &
Hose Assembly