Installation guide

2
1. The boiler and all the associated
equipment must be installed and used in
accordance with the installation design,
all the corresponding valid legal
prescriptions and technical norms and
with the manufacturer’s instructions.
2. The boiler may be installed only in an
environment for which it is designed.
3. After installation, the boiler may be put
into operation by an authorised service
organisation only.
4. The boiler complies with the prescriptions
valid in the Slovak Republic. When used
in the conditions of other countries, any
applicable deviations must be identifi ed
and addressed.
5. In the event of a defect call the
manufacturer’s service organisation –
any unauthorised intervention may
damage the boiler (and possibly also
associated equipment!).
6. The service technician putting the boiler
into operation for the fi rst time is obliged
to familiarise the user with the safety
elements of the boiler, their characteristics
and with the relevant required response
of the user, with the fundamental parts of
the boiler and manner of use of the
boiler. If this technician is also delivering
the boiler, he/she must ensure that the
original packaging of the boiler is
available for potential further transport
thereof until the moment of launch into
operation.
7. Check whether the delivery is complete.
8. Check whether the model and type
supplied corresponds to the type required
for use, i.e. check whether the data
relating the boiler settings stated on the
plate correspond with the data relating to
the local network supplying fuel (gas) to
the place of installation, or have this
performed by a professional technician
who shall install the boiler or put it into
operation.
9. Whenever you are not suffi ciently certain
of how to control the boiler, seek out and
study all the corresponding instructions
in this Operation and Installation Guide
carefully and proceed accordingly.
10. Never remove or damage any markings
and signs on the boiler. Also store the
original packaging of the boiler in an
undamaged condition for potential
further transport in the case that the
boiler is not put into operation.
11. . . . When performing any repairs, only
original parts may be used. It is prohibited
to make any changes to the boiler’s
internal installation, or to interfere with
this in any way.
12. . . When shutting the boiler down for a
longer period of time, we recommend
that you close the gas supply and
disconnect the boiler from the electricity
network. This recommendation applies
in conjunction with the general conditions
stipulated in this Operation and
Installation Guide.
13. At the end of its useful life, the boiler or
its parts must be disposed of ecologically,
in a manner which avoids causing any
harm to the environment.
14. . The manufacturer is not liable for and
provides no warranty for damages
caused by the failure to abide by:
• the conditions stipulated in this Operation
and Installation Guide;
• prescriptions and norms;
• proper installation and operation
procedures;
• conditions stated in the Warranty
Certifi cate and the Service Book.
15. .If the boiler is delivered to the user by
the technician who also installs the
boiler, this technician is also obliged to
present to the user all the accompanying
documentation for the boiler (in particular
Introduction