user manual

Tsunami MP.11 Installation and Management
6. Connect one end of an Ethernet cable to the Ethernet port. The other end of the cable should
not be connected to another device until after installation is complete.
º Use a straight-through Ethernet cable if you intend to connect the router to a hub, switch,
patch panel, or Active Ethernet power injector.
º Use a cross-over Ethernet cable if you intend to connect the router to a single computer.
7. If you are not using Active Ethernet, or you want to connect the router to Active Ethernet and AC
power simultaneously, attach the AC power cable to the router’s power port.
Once attached, the power cable locks into place. To disconnect the power cable, slide back the
black plastic fitting and gently pull the cable from the connector.
8. Connect the free end of the Ethernet cable to a hub, switch, patch panel, Active Ethernet power
injector, or an Ethernet port on a computer.
9. If using AC power, connect the power cord to a power source (such as a wall outlet) to turn on
the unit.
10. Place the unit in the final installation location (see “Mounting the MP.11” on page 14 for details).
11. Replace the back cover, front cover, and cable cover. Be careful to avoid trapping the power and
Ethernet cables when replacing the cable cover.
Attaching a Kensington Security Lock (Optional)
If so desired, you can attach a Kensington lock to secure the cable cover into place. This protects
the unit from unauthorized tampering.
The MP.11 enclosure includes a Kensington Security Slot for use with a Kensington locking
mechanism. When properly installed, a Kensington lock can prevent unauthorized personnel from
stealing the MP.11. In addition, the Kensington lock secures the cable cover in place, which prevents
tampering with the Ethernet and power cables.
Chapter 2. Installation 11
CPN 63708 Issue Date: 02/05/2003