user manual

Tsunami MP.11 Installation and Management
8. Place the back cover on the mounting location and mark the center of the three mounting holes.
9. Remove the cover from the wall and drill a hole at each of the locations you marked above. Each
hole should be wide enough to hold a mounting plug (which is 6 mm x 35 mm).
10. Insert a plug into each hole. The MP.11 comes with four 6 mm x 35 mm plugs; you only need to
use three of these when wall-mounting the unit.
11. Insert a screw into each of the mounting holes molded into the back cover. The MP.11 comes
with four 3.5 mm x 40 mm pan-head screws; you only need to use three of these when wall-
mounting the unit.
12. Insert the screws into the wall plugs. Use a screwdriver to tighten the screws and attach the
back cover to the wall. In the following example, the back cover is mounted upside down (the
two holes are at the bottom).
13. Attach Ethernet and power cables to the MP.11 unit, if necessary.
14. Snap the unit into the back cover. In the following example, the unit is mounted upside down
and its antenna is facing down.
15. Replace the front cover.
16. Replace the cable cover.
17. Turn on the MP.11 (see “Switching On the MP.11” on page 12).
Chapter 2. Installation 15
CPN 63708 Issue Date: 02/05/2003