user manual

Tsunami MP.11 Installation and Management
HyperTerminal Connection Properties
The serial connection properties can be found in HyperTerminal as follows:
1. Start HyperTerminal and select Properties from the File menu.
2. In the Connect using: drop-down list, select Direct to Com1 (depending upon the COM port
you use) and click Configure…; a window such as the following is displayed.
3. Make the necessary changes and click OK.
4. From the Hyperterminal Properties window, click the Settings tab; then click ASCII Setup…;
a window such as the following is displayed.
5. Ensure that Send line ends with line feeds is selected and click OK.
6. Click OK again to exit the Properties window.
HyperTerminal is now correctly configured.
Chapter 3. Management Overview 23
CPN 63708 Issue Date: 02/05/2003